In this video, we show you how to install the Ambient BSD Blind Spot Alarm on Tesla Model 3, Model Y, Highland, and the New Model Y Juniper. 📹 Save this page — any future software upgrades will be shared here. Thanks for watching!
Controlled by the right steering wheel roller
New Model 3 Highland & New Model Y Juniper: Check It Now>
Model 3 & Model Y : Check It Now
F &Q
Functions & Usage:
Color & Brightness adjust:
1 For Model 3 Highland and the new Model Y Juniper, the ambient light color is adjusted via the vehicle's main touchscreen settings.
2 For the refreshed Model 3 and Model Y, the ambient light brightness is adjusted via the vehicle's main touchscreen settings.
3 For older Model 3 and Model Y vehicles, the ambient light brightness changes in sync with the vehicle's main touchscreen brightness setting.
4 For older Model 3 and Model Y vehicles, ambient light color is adjusted using the right steering wheel scroll wheel: long-press the wheel to the right for 2 seconds to enter adjustment mode, then scroll up or down to change the color; the mode exits automatically after 5 seconds of inactivity.
Warning Instroduction :
5 Overspeed warning: a red light segment appears at the front of the steering wheel.
6 Blind spot warning: a yellow light segment appears on the side where a vehicle is approaching from the rear.
7 Blind spot warning: a red light segment appears on the side where a vehicle is approaching from the rear with its turn signal on.
Welcome Mode:
8 Door opening: a green light flows from the center toward the opening side as a welcome effect; if the door remains open, a short red segment appears on the opening side.
Temperature adjust:
9 Temperature or airflow adjustment (low to high): a red light flows from left to right.
10 Temperature or airflow adjustment (high to low): a blue light flows from right to left.
11 Autopilot (AP) engaged: a tricolor light display appears at both ends.
12 Mode Switching: Long-press the left steering wheel scroll wheel to the left for 2 seconds to enter adjustment mode; press the left scroll wheel to the right to cycle through modes (each press switches the mode). There are three modes: Original Vehicle Mode, Throttle Mode, and Breathing Mode.
13 Original Vehicle Mode: Ambient lights remain constantly on; functions 1 through 10 operate normally.
14 Throttle Mode: The center of the light strip glows red; as throttle input increases, the red light expands outward toward both ends.
15 Breathing Mode: Light strip brightness pulses like human breathing (alternating between bright and dim); when a turn signal is activated, the corresponding side flashes green.
16 Switching between 120cm and 115cm lengths: Long-press the left scroll wheel to the right for 2 seconds to toggle between 120cm and 115cm lengths. When switching from 120cm to 115cm, the display length for the right-side turn signal and blind-spot warning shortens to match the left side.
17 LHD/RHD Setting: Press and hold the left scroll wheel downward while pressing the right scroll wheel to the left once to switch to RHD (Right-Hand Drive) mode.
18 Overspeed Alert (Default: Off): Press and hold the left scroll wheel downward while pressing the right scroll wheel to the right once to toggle the alert on or off.
19 Reduce overspeed alert brightness.
For Product Details: Check It Now
Support: support@satonic-autoparts.com
